Contents
Important safety information
Explanation of symbols
The following symbols are used in this guide and on the
device:
Symbol
Meaning
Warning
Indicates a risk of injury or health
hazards.
Warning
Indicates a risk of injury or health
hazards caused by electrical volt-
age.
Important
Indicates possible damage to the
device/accessories.
Note Indicates important information.
The following annotations are used in the text:
Meaning
…
…
Required action to be carried out in a set or-
der
…
List without a set order, given either in the text
or warning notice
Intended use
Only use the device for the purpose for which it was built
and designed. Any other use is considered unintended!
This device may only be used for the following pur-
pose(s):
• This 4-channel video recorder is used in combination
with connected video signal sources (network cam-
eras) and video output devices (TFT monitors) for
object surveillance.
Note
Data storage is subject to national data privacy
guidelines.
When carrying out the installation, advise your
customers of the existence of these guidelines.
General
Before using this device for the first time, please read the
following instructions carefully and observe all warning
information, even if you are familiar with the use of elec-
tronic devices.
Warning
All guarantee claims are invalid in the event of
damage caused by non-compliance with this user
guide.
We cannot be held liable for resulting damage.
Warning
In the event of personal or material damage
caused by improper operation or non-compliance
with the safety information, we cannot be held lia-
ble.
All guarantee claims are void in such cases.
Retain this handbook for future reference.
If you sell or pass on the device to third parties, you must
include these instructions with the device.
This device has been manufactured in accordance with
international safety standards.
Power supply
• Only operate this device through a power source
which supplies the mains power specified on the type
plate.
• If you are unsure of the power supply available to
you, contact your energy provider.
Warning
Prevent data loss.
Always use the device with an uninterruptable
power supply UPS with surge protection.
• Disconnect the device from the power supply before
carrying out maintenance or installation work.
• The on/off switch on this device does not fully dis-
connect it from the mains supply.
• To fully disconnect the device completely from the
mains, the mains plug must be withdrawn from the
mains socket. The device should therefore be posi-
tioned so that there is always direct and unimpeded
access to the mains plug and the plug can be re-
moved immediately in the event of an emergency.
6
To Next Page
Loading...
