AccuEnergy Acuvim II series - Page 163

155
10. Set HTTP port in the eighth setting page, such as 80. Press the "V/A" key to
go to the setting page. Users may set the parameters pointed out in Fig 5-36.
The cursor starts at the rst digit. After setting the HTTP port, press the "V/
A" key to accept. Press the "P" key to go to the ninth setting page for the reset
mode. The HTTP port's default value is 80, and the user dened range of port is
6000~9999. If the set port is not in the correct range, the set port will return to
the default value.
Fig 5-36
11. Set resetting mode in the ninth setting page. Select “RESET” to reset the
module. Selecting “NO” will not reset the module. Selecting "DEFAULT" will load
the module with default settings and reset module. Press the "V/A" key to go to
the setting page and the parameter pointed out in Fig 5-37 will ash. Press the
"P" or "E" key to select the conguration mode. Press the "V/A" key to accept.
Note: When conguring Ethernet module settings completely, users must select
“RESET” to restart module and new settings will take eect.