AccuEnergy Acuvim II series User Manual

49
3.7 Parameter Setting Mode
Pressing H and V/A simultaneously will activate the display mode selection
and the cursor will ash. Press P or E to move the cursor right or left. To enter
parameter setting mode, move the cursor to "Setting" then press V/A.
In the parameter setting mode, parameters such as system parameters,
expanded I/O module parameters, alarm parameters and Ethernet module
parameters, can be read and modied.
a) Password Inquiry:
Parameter setting mode is password protected. Before entering the
password and getting into the parameter setting mode, the meter's device
communication address will display for 3 seconds. A four digit password (0000
to 9999) is required everytime before accessing the parameter setting mode.
The default password is 0000. After entering the password, press V/A to go to
the parameter selection page. The meter will be still in the password inquiry
page if a wrong password is entered.
The following gure shows the password inquiry page.

AccuEnergy Acuvim II series Specifications

General

Brand	AccuEnergy
Model	Acuvim II series
Category	Measuring Instruments
Language	English