182
module as well.
* The PROFIBUS module can only be used as slave in PROFIBUS network. Its
slave address ranges from 0 to 126, which can only be set by the panel. If the
address is changed, it will take eect immediately.
* The PROFIBUS module’s baud rate can be adaptive between 9.6Kbps to
12Mbps in PROFIBUS network.
* The PROFIBUS module terminals should be connected properly to avoid
problems during installation.
* Please read GSD le of the PROFIBUS module carefully before using. The GSD
le contains technial information such as device name, ID number and so on.
* Please read the communication data format thoroughly as this is a key point
of the PROFIBUS module.
To Next Page
Loading...
