System Utilities 2-15
DOS Flash Utility 0
Perform the following to use the
DOS Flash Utility
:
1. Press
F2
during boot to enter Setup Menu.
2. Select Boot Menu to modify boot priority order.
Example: If using USB HDD to Update BIOS, move USB HDD to position 1.
Figure 2-12. BIOS Boot
3. Copy ZE7_025.exe to a bootable USB HDD.
4. Insert the USB HDD and reboot computer.
5. Execute ZE7_025.exe to update BIOS.
6. Flash is complete when the message, Flash Programming Complete is shown.
System will restart automatically when finished.
If AC power is not connected, the following message is shown
(Figure 2-13). Plug in the AC power to continue.
Figure 2-13. AC Power Warning
http://mycomp.su - Maintenance and Service Guide,Service Manual,Motherboard Schematics for Laptop/notebook
Ремонт ноутбуков.Запчасти и комплектующие для ноутбука. Схемы,сервис мануалы,инструкции по разборке ноутбука.
To Next Page
Loading...
