ACT ACTpro 1520 - IP Address Configuration; Configure DHCP Address; Configure Static IP Address

ACTpro 1500 and 1520 Operating and Installation Manual
Page 12
5.0 IP Address Configuration
5.1 Configuring for DHCP address
1. Remove power from ACTpro 1500 or 1520 controller.
2. Set DHCP switch 1 to the on position (Move switch 1 to the right).
3. Reapply power to the controller.
5.2 Configuring for Static IP address
1. Remove power from ACTpro 1500 or 1520 controller.
2. Set DHCP DIP switch 1 to the off position (Move switch 1 to the left).
3. Reapply power to the controller.
4. Default static IP address is 192.168.1.60.