ACTpro 1500 and 1520 Operating and Installation Manual
Page 8
3.0 Quick Setup Guide
Note: See troubleshooting section of this manual for details on how to factory
default the controller.
Step 1:
Connect ACTpro 1500 or 1520 to the IP network. Controller is defaulted for dynamic IP
address (DHCP). For static (fixed) IP address set DIP switch 1 to the off position (Move
DIP switch 1 to the left). Default static IP address is 192.168.1.60.
Step 2:
Open your web browser on PC (Microsoft Internet explorer, Firefox)
Step 3:
Enter http://act1500-(followed by NetBIOS address).
e.g. http://act1500-59487 (see label on PCB)
Step 4:
Login to controller as installer
Login details:
Username: installer
Password: 999999
To Next Page
Loading...
