Action technology A3 - Change of the Basic Parameter (by Setting Panel); Setting Method for Basic Parameter

52
5.1.4 Setting method for basic parameter
To drive the motor in the different operation modes, the setting and operation of the related basic parameter should be done
necessarily. Here are the steps of parameter setting and change by using ‘setting panel’ and HCX-SETUP’.
■By setting panel
1. Switch on the power supply to the drive
2. Set the basic parameter according to the following steps.
Table 5.1.3 Change of the basic parameter (By setting panel)
Display and operation
Description
Initial display at the start.
Press button four times
Switch to the mode of setting panel.
Switch to the parameter mode. You can change the parameter No. here. (Display
parameter 2.0)
Press button once
Display the setting value of parameter 2.0.
Display the setting value of parameter 2.0.
The flickering bit is changeable.
Press button
Press the UP or DOWN to input the parameters.
Confirm the parameter value. (Display in ‘Speed control mode’.)
Press button once
After setting the parameter on the RAM of the drive, the display changes from flickering to
light.
Press button once
Return to the display of parameter No.
Return to the display to change the parameter No.
(Display parameter 2.0)
Press button
Press UP button to change the parameter No.
Display parameter 3.0.
Press button once
Display the setting value of parameter 3.0.
Press button to set the related parameters. We can go to the next step after all the parameters are set.
Press three times
Switch to the mode of setting panel.
Switch to parameter saving mode.
Press button once
Save the parameter to the EEPROM in drive.
(When saving, 『P』 in 『SAVE_P』 will flicker.)
To the end.
-
Please cut off the power supply to the drive and restart. After restart the power, the setting
237.0
272.1
Parameters of encoder pulse output
276.0
278.0