WPS
Click WPS in any Wireless screen to generate the WPS (Wi-Fi Protected Setup)
screen. WPS provides a simple method of setting up a wireless network by automati-
cally sharing the network key between the R3000 and other wireless devices. To begin,
select the frequency of the network, enable WPS by clicking in the appropriate button,
then click Apply.
There are three ways to set up WPS on the R3000: AP PIN, Push Button (PBC),
and End Device PIN.
AP Pin
1. Use the current WPS AP PIN (displayed in blue), or generate another PIN by
clicking Generate PIN. Clicking Restore Default PIN uses the factory default
PIN.
2. Write the PIN down.
3. Enter the PIN on another wireless device’s WPS AP PIN configuration to have that
device join the wireless network.
To Next Page
Loading...
