To set up port forwarding
1. Enter the LAN starting port in the “Starting Port” text box.
2. Enter the LAN ending port in the “Ending Port” text box.
3. Select a protocol from the “Protocol” drop-down list box
4. Enter the LAN IP address in the “LAN IP Address” text box.
5. If applicable, enter the remote port and IP information
6. Click Apply to save your changes.
The list of forwarded ports will be displayed in the “Applied Port Forwarding
Rules” at the bottom of the screen.
Applications
Click Applications from any Firewall screen to generate the “Applications” screen.
This screen is an extension of the port forwarding screen, allowing you to quickly
and easily set up commonly-used applications that require port forwarding
To Next Page
Loading...
