ActionTec V1000H User Manual

6
Wireless VDSL Modem Router
Line Port
The Line port is used to connect the Modem Router to a telephone line connection.
HPNA Port
The HPNA port is used to connect the Modem Router to an HPNA connection
via coaxial cable.
LAN Ethernet Ports (4)
The LAN Ethernet ports are used to connect computers to the Modem Router
via Ethernet cable. The Ethernet ports are 10/100/1000 Mbps auto-sensing ports,
and either a straight-through or crossover Ethernet cable can be used when con-
necting to the ports.
WAN Ethernet Port
The WAN Ethernet port is used to connect the Modem Router to a WAN via an
Ethernet cable.
USB Port
The USB port is used to connect the Modem Router to a USB device. This port is
not yet active; it may be activated in a future firmware update.
Reset Switch
Depressing the Reset switch for one second will restore the Modem Router’s
factory default settings. To reset the Modem Router, depress and hold the Reset
switch for approximately ten seconds. The reset process will start after releasing
the switch.
Power Port
The Power port is used to connect the Power cord to the Modem Router.
WARNING! Do not unplug the Power cord from the Modem Router
during the reset process. Doing so may result in permanent damage to
the Modem Router.

ActionTec V1000H Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Wi-Fi standards	802.11b, 802.11g, Wi-Fi 4 (802.11n)
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
Antennas quantity	2
RJ-11 ports quantity	1
Ethernet LAN (RJ-45) ports	4
Firewall security	Application-level gateway (ALG), Protocol and generic packet filter
Security algorithms	WEP, WPA, WPA2, WPS
Dimensions (WxDxH)	- mm
Product color	Black

Weight and Dimensions

Weight	- g