25
Operation Manual
LC7-2 Wall Control
Operation Manual - LC7-2 Wall Control
Document: 0525-080 Ver. 1 190923
4. Press the or buttons to scroll from OFF to ON.
5. Press the PROG button to confirm the selection.
6. Press the EXIT button thrice to go back to Main Screen.
13.03.02. Setting Temperature Set Back
NOTE
The Set back mode Cool to and Heat to limits can only be adjusted from the temperature set back menu. In the
occurrence of when the unit’s setpoint (prior to Set back operation) is below the Heat to limit or higher than the
Cool to limit, the unit’s setpoint will automatically become the new Set back limit.
1. Press the PROG button to enter program Menu.
2. Press the or buttons to navigate to Program Menu 03.
3. Press the PROG button to enter Program Menu 03. Display will show set back display ON field is blinking.