31
Operation Manual
LC7-2 Wall Control
Operation Manual - LC7-2 Wall Control
Document: 0525-080 Ver. 1 190923
4. Press the PROG button to enter Program Menu 05.
NOTE
Setpoint lock is OFF by default.
5. Press the or buttons to turn the setpoint lock ON.
6. Press the PROG button to accept the selection.
7. Press the EXIT button once to go back to main Screen
8. When the or buttons is pressed. The symbol will appear for 3 seconds and user will not
be able to change set temp.
NOTE
To disable setpoint Lock, follow same steps above. However, in step 5 select OFF.
To Next Page
Loading...
