Acura 1994 Integra User Manual

Install the oil
tilter by hand.
After
the rubber sesl
seats, tighten
the oil
filter clock-
wise with
the special tool.
Tighten:
7/8 turn clockwise.
Tightening
torque:
22 N.m
(2.2
kgf'm,
16 lbf'ft)
CAUTION:
Installation other
than the abova
ploce-
dure
could r6suh
in serious
engine damag€
due
to
oil
leakage.
OIL
FILTEB WRENCH
07912-6110001
4.
_l-
8-7
Eight numbers
{'l
to 8) are
printed
on
the surface of
rhe filter.
The following
explains the
procedure
for tightening
filters using
these
numbers.
1 ) Make a
mark on the
cvlinder
block under
the num-
ber that shows
al the bottom
of the
filter when
the
rubber seal
is seated.
2) Tighten
the tilter by
turning
it
clockwise
seven
numbers
from the
marked
point.
For example,
if
a mark is
made under the
number
2 when the
tub-
ber seal
is seated.
the filter should
be
tightened
until
the number
'l
comes
up to the
marked
point.
Number
when rubber
seal
is seated.
Number after
tightening.
MARK
Number
when rubber
seal
is seated
4 6 I
Number after
tightening 8
?
o 7
5. After
installation,
till the engine
with oil up
to the
specified
level,
run
the
engine
for more than
3
minutes,
then check
for oil leakage
and oil level.
.41

Acura 1994 Integra Specifications

General

Brand	Acura
Model	1994 Integra
Category	Automobile
Language	English