Acura 1994 Integra - Bearing Replacement; Oil Seal Removal

NOTE: Check
the ball bearings
for wear and
rough ro-
tation. It bearings are OK,
removal
is not necessary.
1.
Remove the ball bearings
using a standatd
bearing
puller
and bearing separator as
shown.
BEARING PULLEB
BALL BEARING
Install new ball bearings using the special
tool
as
snown.
NOTE: Drive the bearings
squarely until they bot-
tom
against
the carrier.
DRIVER, 40 mm
l.D.
07746-0030100
BALL BEARING
Bearing
Replacement
Oil
Seal
Removal
1. Remove the
ditterential assembly.
Remove the 8O
mm shim
from the transmission
housing.
80 mm SHIM
TRA[{SMtSStON
HOUSING
3.
Remove the oilseal
from the t.ansmission
housing.
4. Remove the oil seal from the clutch
housing,
OIL SEAL
R€plac6.
15-5