Acura 1994 Integra - Mainshaft Thrust Clearance

Mainshaft Thrust Clearance
Adjustment
(cont'd)
MAINSHAFT
-),.
"7t/'-
'..'
.'i'
-7.
Slide the mainshaft base over the mainshaft.
i.,
MAINSHAFT BASE
07GAJ
-
PG20130
-8.
Attach
the
mainshaft
holder to the mainshaft as fol-
NOTE:
.
Back-out
the
mainshaft holder
bolt and
loosen
the two hex bolts.
.
Fit the holder
over the
mainshaft
so
its lip is
towards the transmission.
.
Align
the
mainshaft holder's lip
around the
groove
at the inside ot the mainshaft
splines,
then tighten the hex bolts.
MAINSHAFT HOLOER
BOLT
f- t{-c
lnrTh l\nex
|
\-_.r'
\
._/_/
lrl
Borrs
L
___E_J
\
MAINSHAFT
HOLDER
07GAJ
-
PG20110
MAINSHAFT
BASE
07cAJ
_
PG20130
-9.Seat
the
mainshaft fully
by tapping
its
end with a
plastic
hammer.
-10.Thread
the mainshaft holder bolt in until it
just
con-
tacts the wide surface of the mainshaft base.
-
1 1. Zero
a dial
gauge
on the end of the mainshaft.
12.Turn the mainshaft holder
bolt clockwise; stop turn-
ing when the dial
gauge
has reached its maximum
movement. The reading
on the dial
gauge
is
the
amount of mainshaft
end
play.
CAUTION: Turning
the mainshaft holder bolt mor€
than 60 degrees after
the
needle
ol the dial
gauge
stops moving may
damage the transmission,
DIAL GAUGE
MAINSHAFT HOLDER
07GAJ
-
PG201r0
-
13.lf the reading is within the
standard, the clearance is
correq.
lf the reading is not within
the standard, recheck the
shim thickness.
Standard:
0.11
-
0.18 mm
{0.004
-
0.007 in)
\
13-40