Acura 1994 Integra - Flywheel, Flywheel Bearing; Replacement

Inspection
Replacement
Flywheel,
Flywheel Bearing
Inspect
the ring
gear
teeth for
wear and damage.
Inspect
the clutch disc mating surface
on the
flywheel
fo. wear,
cracks,
and burning.
Measure the
flywheel runout using a
dial indicator
through at
least two full tu.ns.
Push against the
Ilywheel each time
you
turn
it to take up the crank-
shaft
thrust washe. clearance.
NOTE;
The runout can be measu.ed
with engine in-
stalled.
Standard
(ttlervl:
O.O5 mm
(O.002
inl Max.
Service
Limit: 0.15 mm
10.006
inl
RING
GEAB
FLYWHEEL
DIAL
II{DICATOR
It the
runout
is more than
the service
limit, leplace
the
flvwheel.
Turn the inner
race
of
the flywheel
bearing with
your
finger.
The bearing should
turn smoothly
and
quiet-
ly, Check
that the bearing outer
race fits tightly
in
the flvwheel.
FLYWHEEL
BEARING
It the race does
not turn smoothly,
quietly,
or
fit
tight in the
flywheel, replace
the flywheel bearing.
Install
the special tool.
Remov€ the flywhe€l
mounting bolts
in a criascross
pattern
in several steps 8s
shown, then
remove the
tlywheel.
MOUI{TII{G BOLTS
3.
Remov€ the
flywheel bsaring
from th€
tlywheel.
(cont'd)
FLYWHEEL
12-9