Acura 1994 Integra - Maintenance Transmission Oi1; Back-Up Light Switch; Replacement

-
Transmission Oil
NOTE: Check
the oil with the engine OFF,
and the car on
level
ground.
1. Remove the oil
filler
plug,
then check the
level and
Maintenance
condition of
the oil.
OIL
FILLER
PLUG
44 N.m
lia.5
kgf.m,
ORAIN PLUG
$
N.m
14.0
kgf.m.
29
lbf.fr)
33
tbtftl
Proper Level
2. The oil level must be
up to the filler hole.
lf it is
below
the hole. add oil until
it runs out, then
rein-
stall rhe oil
filler
plug.
3.
lf the transmission
oil is dirty, remove the
drain
plug
and drain the
oil.
4.
Reinstall the drain
plug
with a
new washer, and
refillthe transmission
oil to the
proper
level.
NOTE: The drain
plug
washer should be
replaced at
every oil change.
5 Reinstall the oil
filler
plug
with a
new washer.
OilCapacity
2.2
(
''2.3
US.qt,1.9
lmp.qt) at oil chang€.
2-3
I
l2.1Us.ql,2.0lmp.qtl
at oyerhaul.
Use only SAE
10 w
-
30 or
'10
W
-
40, API Service
SF
or SG
grade.
OIL
FILLER PLUG
a4 N.m
l{.5
kgf.m,
33 lbf.ftl
Back-up
Light
Switch
Replacement
NOTE: To check the back-up light switch,
1. Disconnect the connector,
then rem(
light switch connector
trom the conn
2. Remove the back-up
light switch.
BACX-UP LIGHT SWITCH
25 N.m
12.5
kg[.m, 18 lbf.ftl
lnstall the
new washer and the back-
Check the transmission
oil level
(see
Replace.
/itch,
see section 23.
remove the back-up
]onnector clamp.
-up
light
switch.
)
page
13-3).
Replace.
13-3