Hot Water Storage Tanks
1. Removable top cover
2. Control panel
3. Stainless steel tank
4. Polyurethane foam
insulation
5. Front panel
6. Stainless steel coil heat
exchanger (HRS) or
connection for
immersion heater (HRE)
7. Steel base
8. Drain connection
9. Coil connection (HRS)
or auxiliary connection
(HRE)
10. Coil connection (HRS)
or auxiliary connection
(HRE)
11. DHW recirculation or
temperature and
pressure relief valve
connection
12. Cold water connection
13. Hot water connection
Product Description
HRS / HRE
1
2
3
4
5
6
7
8
9
10
9
10
11
12
13
1
2
3
4
5
6
7
8
9
10
11
12
13
• Stainless steel construction (including coils)
• Fully insulated with rigid polyurethane foam
• Stove enamelled casing
• Control panel including thermostat and thermometer
• Vented or unvented use,with mains pressure SystemPak available
HRS
• Indirect hot water storage tank with single high recovery coil (HRS1) or double coils (HRS2)
• Ideal for very high primary pressures or for use with a solar collector
• Available in four sizes - 275 and 467 litres (HRS1) or 269 and 461 litres (HRS2)
HRE
• Direct hot water storage tank
• Ideal as a buffer store for plate heat exchangers and heat recovery units
• Supplied with two 1
1
/2
”
female BSP connections to allow immersion heaters to be added
• Available in two sizes - 281 and 473 litres
9
HR S2
HRE
HRS / HRE
To Next Page