7451A/7461A/7461P Digital Multimeter Operation Manual
8.11 Error Message List
8-23
If the error cannot be fixed by the described solution, contact an ADC CORPORATION sales representative
this instrument.
39 Err-200 Execution error (Command which cannot be executed now)
[Execution error]
Solution7
40 Err-213 The INITiate command is ignored because the measurement
is performing.
[Init ignored]
Solution7
41 Err-214 The READ? or MEAS? command is received when any trig-
ger source except for IMM is set.
[Trigger deadlock]
Solution7
42 Err-221 The command cannot be executed in the current setting con-
dition.
[Settings conflict]
Solution7
43 Err-222 Entered value is outside the setting range or lacking for nec-
essary parameters
[Data out of range]
Solution7
44 Err-313 Calibration data is lost.
[Calibration memory lost]
Solution8
45 Err-314 Parameters saved by “*SAV” command are lost.
[Save/recall memory lost]
Solution9
46 Err-315 Saved parameters are lost.
[Configuration memory lost]
Solution7
47 Err-330 Self-test error
[Self-test failed]
No solution
48 Err-350 Error queue overflows.
[Queue overflow]
Solution10
Solution1 Set the correct function.
Solution2 Check the USB cable connection
Solution3 Check the entered value.
Solution4 Calibrate according to the correct procedure.
Solution5 Perform the ZERO cancellation.
Solution6 Send the correct command
Solution7 Check the settings.
Solution8 Re-calibrate.
Solution9 Re-set.
Solution10 Read out the error queue.
No. Error display
Error description
[ ]: Response to the ERR? command
Solution
To Next Page
Loading...
Need help?
General
