19
8. Basic Operation
The basic mode is the split screen that shows MEASURE and SOURCE areas
on the display(see figure 8.1). When returning from higher level operations (e.g.
Setup,Task, measuring options, sourcing options, etc), the calibrator will lso
eturn o he asic ode ith ast onfigured easurement nd ource.
In Basic ode, ou an ress he avigation eys o elect etween
he EASURE r OURCE reas. ou ill ee ither EASURE or SOURCE
highlighted, which means this display area is active. Function toggled keys( ,
, , , ) are used to select the MEASURE or SOURCE function.
In the Basic Mode you can perform the following:
Measure signals and zero the measured value.
Note: The calibration data(refer to section 9.6 system calibration)will be
changed once zero trim is performed, and can be restored manually.
Source/Simulate signals. Stepping, ramping(if allowed), set, and reset
source value.
Figure 8.1 The Basic Mode
To Next Page
Loading...
