48
Then we should set the tolerance and the calibration set points (as shown in
Figure 10.4).
The tolerance should be set correctly Otherwise it will cause undesired result
Change the calibration points (2 to 11) by press the navigation keys Left/Right,
the default set points will be calculated utomatically.
The default set points are typical values for calibration. If you want to change
the value of the task, select the task in the task list then press Edit to make
Press Enter or Finish when editing is complete.
10 3 Delete Erase Tasks
To delete tasks from the memory proceed as follows:
On the Tasks List page, select the task which you want to delete. Press Delete
and the confirmation dialog box will appea.The task and its calibration data will
be deleted permanently by pressing Enter.
To erase all tasks(and their calibration data),select “Erase All Tasks” in the
Task Management page,and press Enter or Select.
10 4 Select a Task to Be Calibrated
A task which is already completed is marked with“√” in the list of tasks (as shown in Figure 10.5).
If there is no task in the calibrator's database, you can download them from Additel/Cal or create tasks in the calibrator (refer
to previous section).
Figure 10 4 Task UUT Calibration Data
To Next Page
Loading...
