54
10 5 Viewing the Task Results
On the Task List page select a completed task (marked with “ ”) and press
You can re-calibrate the DUT by pressing Enter or AsCal as described in the
previous section.
If you want to create a similar task based on the current task, you can press
Save As to re-name the parameters of the task and save them.
and calibration data will appear (as shown in Figure 10 11). If both as found
and as left are available the arrows on top of page will be enabled Press the
navigation eys to scroll the page, and the as-found and as-left
calibration data will display.
Press Esc or Back to exit the task results.
Figure 10 11 Task Result
√
To Next Page
Loading...
