37
The transmitter is a device which can measure temperature, electrical signals and pressure, etc. Generating a signal according
to the measurement imposed.
The calibrator can simulate a transmitter. It can measure RTDs, thermocouples, frequency, volts, mA, ohms and pressure
(when the pressure module is connected), and output mA and volts signal.
After selecting simulate transmitter the Quantity page will appear and you can chose from various sensor types and the
transmitter output (as shown in Figure 9 2).
On the Range page, set the input range 0 to 200°C and the output range 4 to 20mA. Sometimes, it is necessary to set the
transfer function: Linear/Square root (as shown in Figure 9.3).
To Next Page
Loading...
