31
Run Mode (Repeat or Single shot).
3. To complete the ramp settings, press Enter or Done then the calibrator will return to the Basic Mode showing the main
screen.
4. Press Enter or Start to begin automatic ramping, and the soft key label will change to Pause.
5 Press Pause to pause automatic ramping, and the soft key label will change to Resume. Press Resume to resume ramping.
If you want to exit automatic ramping, press Esc or Exit.
1 If the source area is active press once otherwise press twice.
2 You can Press the navigation keys Up/Down to select mV from the list, then press Enter or Done to change the source
to millivolts.
3
1 If the source area is active press once otherwise press twice.
2. ress he avigation eys o elect olts rom he ist, hen ress r o hange he ource o olts.
3
1. If the source area is active, press once, otherwise press twice.
2. Press the navigation keys Up/Down to select Hz from the list, then press Enter or Done to change the source to frequency
or press Options soft key to show the frequency source setup interface. In the frequency source setup interface, you can
set the amplitude.
To Next Page
Loading...
