25
The calibrator supports 11 common RTDs shown in Table 5-4. In addition, calibrator
accepts 10 custom RTDs (to add a custom RTD please refer to 9.4.3). The calibrator
accepts RTD measurement inputs in two-wire, three-wire, or four-wire connections
as shown Figure 8 10 The four-wire connection can provide the most precise measurement
1. If the measurement area is active, press once, otherwise press twice.
2. Press the navigation keys Up/Down to select RTD from the list, and then press
Enter or Done to change the measurement or press Options to view the setup
interface.In setup interface, you can set the RTD sensor type, connections and
temperature units (°C, K, ℉ ).
the resistance measurement.
In the Basic Mode (Figure 8.1), if the source area is active, you can press ( , , , , ) which will display
the relevant source item list. If the measurement area is active, you can press the desired switch key ttwice which will activate
the source area. Or by pressing the navigation keys Up/Down, you can activate the source area.
RTD
3W
4W
Figure 8.10 RTD Measurement
To Next Page
Loading...
