Additel ADT22 A Series - Pressure Source(Only Available with Pressure Module); Current Source

1 Figure 8 15 shows the current source connections.
2. If the source area is active, press once, otherwise press twice.
3 Press the navigation keys Up/Down to select the mA with 24V loop power
or mA without 24V loop power from the list, then press Enter or Done to switch
source to current.
4. When sourcing current with internal power, the 24V DC loop power will indicate
it is on If the 24VDC power state is OFF, it will be automatically turned back
ON after switching source to current with internal power.
5. Refer to the sections 8.3.1, 8.3.2, 8.3.3, 8.3.4 or 8.3.5, select a method to
change the source value according to your need.
4. Press the navigation keys Up/Down to select the pressure module from the
list, then press Enter or Done to change the source to pressure.
supported by the calibrator.
Ammeter
24V
mA
mA
Figure 8 15 Current Source
33
Figure 8 16 Pressure Source
223A