29
1. If necessary, press Up/Down until source is active.
2. Press Step to view the step setup interface, and configure these parameters as follows:
Start Value (in units).
End Value (in units).
Step Mode Eng Units Scale or Step Points
Step Size (Scale or Count according to the Selection of Step Mode).
Run Mode (Repeat or Single shot).
Trans Function: Linear or Square Root
Step Time
3. To complete the step settings, press Enter or Done then the calibrator will return to the Basic Mode and show the main
4. Press Auto to begin automatic stepping, and the soft key label will change to Pause.
Press Pause to pause automatic stepping. The soft key label will change to Resume. Press Resume to continue
In the Basic Mode the calibrator offers the source value ramping function Ramping smoothly and continuously increases
or decreases the source value. The size of steps is determined by the start value, end value and the ramp time. Before ramping,
you need to configure the ramp settings Each source item (except pulse frequency and pressure) has its own ramp settings
When the source area is active press Ramp to view the ramp setup interface. Figure 8.13 and Figure 8.14 are examples of
the ramp setting and the ramp results.
To Next Page
Loading...
