Additel ADT22 A Series - Pulse Source

32
2. Press the navigation keys Up/Down to select pulse from the list, and then press Enter or Done to change the source to
pulse or press Options to show pulse source setup interface. In pulse source setup interface, you can set the triggering
edge, amplitude and frequency.
3. Refer to the sections 8.3.1 or 8.3.2 to select a method to change the source value according to your need, to start sourcing
pulse, you must press Start and the soft key label will change to Stop.
2. Press Up/Down to select the desired range (range 1 to 400Ω) from the lists, and then press Enter or the Done to change
the source to resistance simulation.