23
1 Figure 8 7 shows the current measurement connections
2 If the measurement area is active, press once, otherwise press
twice.
3 Press the navigation keys to select mA from the list, then press
Enter or Done to change the measurement.
then press Zero to clear the measured value.
When a pressure module is connected, the pressure module icon will appear
in the status bar and beep at the same time. Figure 8.8 shows the pressure
measurement connections.
1 If the measurement area is active, press once, otherwise press
twice.
2 Press the navigation keys to select the pressure module from the
list, then press Enter or Done to change the measurement.
3 provides you with a list of pressure units to select from.
4. You can press Module to view the pressure module's information and change
the resolution.
5 To improve measurement precision, you can press to clear the
measured value.
Figure 8.8 Pressure Measurement
Source
Source
Measure
Units
Zero
Module
223A
Figure 8.7 Current Measurement
To Next Page
Loading...
