Additel ADT22 A Series - Thermocouples Simulation; RTD Simulation

34
6. You can press Module to view and change information about the pressure
module.
or decreased with an external pressure generation device (such as Additel's
8 3 13 Thermocouples Simulation
Refer to Table 5-3 for data about thermocouple types included in the calibrator.
2. You can press the navigation keys Up/Down to select the TC the list, and
then press Enter or Done o witch he ource o hermocouples imulation.
Press Options to show thermocouples simulation setup interface where you
can set he hermocouple ensor ypes, emperature nits (°C, K, ) nd
eference unction ompensation ethods.
3. Refer to the sections 8.3.1, 8.3.2, 8.3.4 or 8.3.5 to select a method to change
he ource alue ccording o our eed.
Refer to Table 5 4 for information about RTD (Resistance Temperature Detector) types supported
2. Press the navigation keys Up/Down to select RTD from the lists, and then press Enter or Done to switch the source to
RTD simulation or press Options to show the RTD simulation setup interface. where you can set the R TD sensor type
and temperature units (°C, K, ).
TC
6
5
c
Temperature Indicator
F
F
Figure 8.17 Thermocouple Simulation