Additel ADT22 A Series - Page 63

56
The calibrator will try to poll from address 0 to 15. If there is HART device be found at address 0, polling will be stopped and
a HART device list will be displayed. Otherwise calibrator will continue searching from address 1 to 15, and automatically
stop polling at address 15. During polling, you can press Stop to stop polling process. If more than one HART device is
found,calibrator will show the HART device list. A maximum of 15 HART devices can be supported.
3. Press Enter or Select to select a HART device from the list.The calibrator will connect to the selected HART device, and
the HART device information will be displayed (As shown in Figure 11.3).
4. Press Enter r Done nd he alibrator ill o ack o he ain creen n asic ode. he ART ommunication nterface
Figure 11.1 the connection with internal built in resistor Figure 11.2 the connection with external resistor
1
2
3
4
5
6
1
2
6
5
1
2
3
4
5
6
1
6
5
250
2