Automatic mode includes hour record and interval record. The cursor points to the current mode.
As figure 3-1-7-2, the 3 item could decide if the automatic mode is operated automatically after start-up.
【0】: After start-up, it will not operate automatically; 【1】: After start-up, it will operate automatically.
e. If select (HOUR), it returns to the file menu. Then, a record is saved every hour.
f. If select the (INTERVAL), the screen enters into the interval interface. (The interval range: 1 second ~ 99 hours
99 minutes and 99 seconds). After setup, it returns to the record mode. Then, a record is saved at every interval.
g. If select (RUN_0), screen displays (RUN_1). Item is short-term logging,
item is long-term logging.
The operation steps:
a. Select and press .
Under the manual mode: cursor points to saved file's serial number;
Under the automatic mode: cursor points to the previous file's serial number.
b. Please return to the main interface by pressing , then ADT672 enter into the save-file status.
Press to quit.
rd
Remark: If long-term record mode is set, the electricital type and pressure unit cannot be changed.
3.1.8 Enter save-file status
3.1.9 Quit save-file status
31
To Next Page
Loading...
