Adleepower BL2-104 - Page 60

58
L : 0~2000RPM.
M : 0~3000RPM.
H : 0~6000RPM.
HX : 0~9999RPM.
Note : This parameter does not work in open loop control.
Setting Range 0 or 1
Default value 0
Set address CD30=1 to reset parameters to be in default values.
This parameter value will be back to 0 after reset command auto-
matically.
Reset to default
CD30
L : 0~2000RPM.
M : 0~3000RPM.
H : 0~6000RPM.
HX : 0~9999RPM.
Note : This parameter does not work in open loop control.
Setting Range
0 ~ 6000RPM /
0 ~ 9999RPM
Default value 1000RPM
Setting Range
0 ~ 6000RPM /
0 ~ 9999RPM
Default value 2000RPM
1
st
close loop
speed
CD28
2
nd
close loop
speed
CD29