– 42 –
System Programming (cont’d)
Changing the Time and Date
Your FOCUS
CADET security system contains a real-time clock and
calendar, which must be programmed at the time of installation. Periodically
check the clock and calendar to ensure their accuracy. The time and date
may require re-entering if both AC power and battery power have been
interrupted or disconnected. If a change is required, complete the steps
below.
Changing the Current Time
Note: Before changing the time or date, turn off all BA groups.
1.
Using the operating panel’s numeric keypad, enter a valid ID code that
has been assigned the privilege level of "Change perm sched" or "Change
temp sched."
2.
Press
More
twice to display Action Menu 3.
3.
Press
Time
to display the Time Selection Menu.
Time Selection Menu
?Time:
Holida
Da
li
ht
O
en/close Hst
Quit Current
4.
Press
Current
to display the current time and date settings of the system.
5.
Press
Change
to display the selector buttons “Change time” and “Change
date.”
Note: Change will not appear unless all BA groups are off.
To Next Page
Loading...
Need help?
General
