ADT FOCUS CADET User Manual

– 72 –
System Test (cont’d)
Protection Groups
Use this test to determine if the selected Burglary group is ready to turn on.
1. Using the operating panel’s numeric keypad, enter a valid ID code to
display Action Menu 1.
2. Press
More
to display Action Menu 2.
3. Press
Test
to display Test Menu 1.
4. Press
Burglary groups
to display the "Burglary Group Descriptions."
5. Press
Previous
or
Next
to display the “Group description” to be tested.
6. Press
Group description
to test that specific group and to display the
test results.
7. Press
Quit
to display Action Menu 2.
8. To test additional groups, repeat steps 3 through 7.
Testing Holdup, Fire, and Supervisory Devices
Caution: Use care when conducting this test. All holdup, fire, and
supervisory functions are disabled during this test mode. In the event of a
security breach or fire, no signals will be sent to the monitoring center.
1. Using the operating panel’s numeric keypad, enter a valid ID code that
has been assigned the privilege level of "Can change perm sched" or "Can
bypass FA/HU/SPV."
2. Press
More
to display Action Menu 2.
3. Press
Test
to display Test Menu 1.
4. Press
Sensor points
to display types of devices to be tested.
5. Press
Holdup, Fire,
or
Supervisory
to display the test instructions.
6. Press
More
twice to scroll through burglar device test instructions. Press
“?”
. Press
More
twice to scroll through fire, holdup, and supervisory test
instruction. Press
Quit
. Press
More
twice for the remainder of the test
instructions.

ADT FOCUS CADET Specifications

General

Brand	ADT
Model	FOCUS CADET
Category	Security System
Language	English