– 54 –
System Operation
Your FOCUS
CADET security system is controlled through operating
panels conveniently located throughout your facility. See
SYSTEM
OPERATION OVERVIEW
section for detailed operating instructions and a
description of the operating panel.
Turning On Burglary Protection
Turning on burglary protection will probably be the most used (and most
important) operation for most sites. Take extra time to practice securing and
exiting your premises. Make sure other operators you depend on for site
closings do the same.
If the operating panel is located within the protected area, you must enter
and exit the premises through a pre-determined entry/exit door. If your
system is programmed with an audible exit delay warning, the operating
panel will beep (once every second) during the exit delay period. You must
exit the protected area and close the exit door securely before the exit delay
expires. A 4-second steady tone indicates the expiration of the exit delay. If
you are detained and hear the 4-second tone, return to the operating panel,
re-enter your ID code, and repeat the process for exiting.
Note: If you do not exit the protected area prior to the expiration of the exit
delay, an “exit fail” signal will be transmitted to the ADT Customer
Monitoring Center.
Turning On ALL Burglary Groups
Before turning on, be sure to secure (or bypass) all protection points.
1.
Using the operating panel’s numeric keypad, enter a valid ID code to
display Action Menu 1.
To Next Page
Loading...
Need help?
General
