1) Open jet delay(s): Open waiting time，The response time required for the glue
gun to open (cylinder). Wait for thisperiod of time after opening glue and then
move the axis to the next point
2) Close jet delay(s): Close waiting time, The response time required for the glue
gun to close (cylinder). Wait for thisperiod of time after closing glue and then
move the axis to the next point (the processing is completed if there is no next
point)
3) Point default delay(s): Default single point time, Default open duration of
single point instruction
4) Ahead glue time(s): Lag/advance opening time, The lag/advance opening time
of the glue gun when the function is used at the start point
※Note: Improper setting of the delay time (for example, the delay is very large,
even if the time of the dispensing path has not been reached) may cause glue
not open on certain track
5) Lag open jet len(mm): The lag opening distance is calculated from the starting
point. When this length is reached, the glue gun is opened.
6) Close jet distance in adv.(mm): Advance closing distance, The distance at
which the glue gun is closed in advance, that is, the needle is closed before it has
reached the end point
※Note: Improper setting of this distance (for example, the value is larger than
the dispensing path) may cause glue not open on certain track
1. ->In handheld box file parameter interface -> Press [ Drawing parameters] -> enter
To Next Page
Loading...
Need help?
General
