Table of Contents Page
1 INTRODUCTION 5
1.1 STANDARDS 5
1.2 CAUTIONS AND WARNINGS 5
1.3 DESCRIPTION 5
1.1 EN54 FUNCTIONS 6
1.1.1 EN54 Optional Features with Requirements 6
1.2 EN12094 FUNCTIONS 7
1.2.1 EN12094-1 Optional Features with Requirements 7
1.3 INSTALLATION APPROVALS 9
1.3.1 Fire System Installations 9
1.3.2 Wiring Regulations 9
2 INSTALLATION 10
2.1 IDENTIFICATION OF PARTS 10
2.2 INSTALLING THE BACK BOX 11
2.3 WIRING INSTALLATION 12
2.3.1 AC Mains Wiring 12
2.3.1.1 Cable Gland 12
2.3.2 Battery Wiring 12
2.3.3 24VDC Power Supply Wiring 13
2.3.4 PSE Configuration 13
2.3.5 External Wiring 13
2.3.5.1 Relay Outputs 14
2.3.5.2 RS485 Communications 14
2.3.5.3 AUX DC Supply Output 15
2.3.5.4 Detection Zone Inputs 15
2.3.5.5 Sounder / Monitored Output Circuits 16
2.3.5.6 Input Circuits 18
2.3.5.7 Actuator Output Circuit 18
2.3.5.8 USB 19
2.3.5.9 Recommended Cable Routing 20
2.4 KEY-SWITCH INSTALLATION 21
2.5 ADJUSTING THE LCD CONTRAST 21
2.6 LOADING CALCULATIONS 22
2.6.1 Panel Loading 22
2.6.2 Battery Standby Calculation 22
3 PROGRAMMING 23
3.1 INTRODUCTION 23
3.1.1 Access Levels 23
3.1.2 Front Panel Controls and Indications 23
3.1.3 Enable Controls 24
3.1.4 Navigating through menus 24
3.1.5 Numeric data entry 25
3.2 RECOMMENDED PROGRAMMING PROCEDURE 25
3.3 LEVEL 3 MENU FUNCTIONS 25
3.3.1 Detection Zones 26
3.3.2 Alarms 26
3.3.2.1 Sounder Configuration 27
3.3.2.2 Pulse Pattern Configuration 28
3.3.3 Extinguishing 29
3.3.3.1 Output Set-Up 29
3.3.3.2 Cause and Effects Programming 29
3.3.3.3 Extract Set-Up 30
3.3.3.4 Release Signal Termination (Test Function) 30
3.3.4 Inputs 31
3.3.5 Outputs 32
3.3.5.1 Switched AUX Output 33
3.3.6 Passwords 33
3.3.6.1 Default Passwords 33
3.3.7 General Options 34
3.3.7.1 Daylight Saving Options 34
To Next Page
Loading...
Need help?
General
