Advanced ExGo Ex-3001

www.advancedco.com
35
Parameter
Comments / Description
Options
Default
Setting
Forward Month
Specifies in which month the time will be shifted forwards
by 1 hour .
JAN – DEC
MAR
Back Order
Specifies which occurance of the day specified (below) in
the month specified (below) the time will be shifted back by
1 hour (at 2AM the time will change to 1AM).
1
ST
2
ND
3
RD
4
TH
LAST
LAST
Back Day
Specifies on which day of the week the time will be shifted
back by 1 hour.
MON – SUN
SUN
Back Month
Specifies in which month the time will be shifted back by 1
hour.
JAN – DEC
OCT
3.3.8 Status Indicators
The display presents a list of the available remote status indicator addresses.
[Status Indicators]
RSI-1 UNUSED
RSI-2 UNUSED
RSI-3 UNUSED
RSI-4 UNUSED
RSI-5 UNUSED
Up to seven (7) RSI panels can be connected to the
extinguishing panel.
Use the  buttons to highlight the required RSI and
then press the  button to select / change it.
[RSI-1 Settings]
ACTIVE: NO .
INPUT-1:
NOT IN USE
INPUT-2:
NOT IN USE
A list of the RSI programmable functions is presented.
Use the  buttons to highlight the required RSI function
and then press the  button to select / change it.
Parameter
Comments / Description
Options
Default
Setting
ACTIVE
Determines if an RSI at this address is connected.
NO / YES
NO
INPUT-1
Determines the action if this input
See Section 0
NOT IN USE
INPUT-2
Determines the action if this input
See Section 0
NOT IN USE
KEYSWITCH
Determines the action if this input
See Section 0
MODE
SELECT
OUTPUT-1
31
Determines the action if this output
See Section 0
NOT IN USE
OUT-1 INVERT
Determines whether the output is inverted (normally on)
NO / YES
NO
OUTPUT-2
31
Determines the action if this output
See Section 0
NOT IN USE
OUT-2 INVERT
Determines whether the output is inverted (normally on)
NO / YES
NO
BUZZER
Determines if the buzzer is in use or not at this RSI
NO / YES
YES
TICK=MUTE
Detemined if the buzzers in the panel and all other RSI
can be muted from this RSI.
NO / YES
YES
31
The optional 2-Way Relay card (Exp-007) must be installed in the RSI for these outputs.