Advantech WISE-4210 Series - Connection; WISE-4210-AP Connection; WISE-4210-Sxxx Node Connection

WISE-4210 Series User Manual 40
4.1 Connection
4.1.1 WISE-4210-AP Connection
WISE-4210 uses the RJ-45 LAN port for configuration. Connect your computer to
Ethernet port of the WISE module with RJ-45 cross-over Ethernet cable, and config-
ure the IP address of your computer as same IP domain as default IP address of
module: 10.0.0.1
Figure 4.1 WISE-4210-AP LAN port
4.1.2 WISE-4210-Sxxx Node Connection
WISE-4210-Sxxx node uses the micro-B USB port for configuration. After removing
the rubber cover on the side of the WISE module, there is a micro-B connector. Con-
nect this port to the computer's USB port for configuration. The USB driver would be
needed for creating a virtual COM port on the computer. Please refer to the following
link to get the latest USB driver: CP210x USB to UART Bridge VCP Drivers (https://
www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-driv-
ers)
Figure 4.2 USB configuration port of WISE-4210 node
Note! Micro-B USB cable for configuring WISE-4210 nodes is available for
ordered:
 1700023619-01 1M micro USB type-B male to USB type-A male
cable