Advantech WISE-4210 Series - Setup WISE-4210 Network; Access WISE-4210 I;O Data by Modbus;Tcp Protocol

47 WISE-4210 Series User Manual
Chapter 4 System Configuration
4.6 Setup WISE-4210 Network
After configuring all end devices into the network with WISE-4210-AP, users can go
to "End Devices" tab to see "End Device List".
 MAC Address: The unique identifier of each end device.
 Modbus ID: Modbus ID is automatically assigned by WISE-4210-AP. User can
configure Modbus ID manually in "Configuration \ Modbus \ Modbus ID".
 RSSI (dBm): Signal strength when data updated from end device to AP. RSSI
will be updated when WISE-4210-AP is receiving data from end node devices. It
is suggested RSSI is higher than -100dBm.
 Inactive Time: Elapsed time since WISE-4210-AP received data from the end
node devices. If end node devices update data every 5 seconds and they have
good wireless signal quality, Inactive Time will go back to 0 or 1 every 5 sec-
onds.
4.7 Access WISE-4210 I/O Data by Modbus/TCP
Protocol
Go to "Configuration \ Modbus \ Modbus ID" to check MAC address of AP and
each end node device, and to configure the Modbus ID. Use Modbus/TCP protocol to
access each end device by WISE-4210-AP, polling different Modbus ID for different
end node devices, or AP.