WISE-4210 Series User Manual 46
Step 5. Go to "Configuration \ Network" to configure LAN port parameters of WISE-
4210-AP.
Step 6. Go to "Configuration \ RF Module" to configure the RF module.
RF Operation Mode: WISE-4210 end node devices support "Push Mode",
communication from the end node device to AP is uplink only, no downlink.
Data Rate (bps): Lower data rates are helpful for extending communication
ranges, while higher data rates can reduce the communication time which
allows more data to be uploaded to AP in the same period of time.
Baseband (kHz): If several WISE-4210-AP or sub-GHz networks are in the
same area, users can select different base bands to reduce the interference of
each network. Note that each WISE-4210 end node device in the same network
should use the same baseband as WISE-4210-AP.
To Next Page
Loading...
Need help?
General
