AENO DB7 - Operation; Selecting the Operating Mode

AENO™ Toothbrush Operation Manual
Document version: 1.0.0, aeno.com © ASBISC Enterprises PLC. All rights reserved
Page 22 of 42
2.2 Operation
The device is intended for daily brushing of the teeth. With the ADB0008 model, it is
also possible to remove plaque thanks to the plaque remover.
The toothbrush has three operating modes:
• “Soft”;
• “Clean”;
• “White”.
A detailed description of the modes is provided in Table 2.
2.2.1 Selecting the Operating Mode
The first time you turn on the toothbrush, it will operate in the “Soft” mode. The last
used mode is saved in the device settings the next time the device is turned on.
To switch the operating mode, follow the steps below:
1. Turn on the device by pressing the power button once.
2. Set the desired operating mode with the subsequent presses of the power
button.
NOTE
You can change the operating mode within 5 seconds after the device was turned
on.
The toothbrush modes will switch in the following order:
• “Soft”;
• “Clean”;
• “White”.
You cannot switch to the first and second modes after switching to the third mode.
Subsequent press of the button (within the current 5 seconds) will turn the device off.
If more than 5 seconds passed since you turned the device on, and you need to change
the mode, turn off the device by pressing the power button once, and then repeat
steps 1–2 above.