AENO DB7 - Using the Plaque Remover and Dental Mirror (for ADB0008 Model Only)

AENO™ Toothbrush Operation Manual
© ASBISC Enterprises PLC. All rights reserved Document version: 1.0.0, aeno.com
Page 25 of 42
6. Turn on the device by pressing the power button once. Set the mode, if
necessary, according to paragraph 2.2.1.
7. Brush your teeth gently, without putting too much pressure on the enamel.
NOTE
The front and back surfaces of the teeth should be cleaned using vertical
movements, going from the gum to the edge of the tooth. The chewing surface
of the teeth should be cleaned using horizontal movements *.
Every 30 seconds the device will notify you to change the cleaning zone by briefly
stopping the vibration. Change the cleaning zone after each notification.
After 2 minutes of operation, the device will turn off automatically. If you want to turn
off the device before 2 minutes have passed, press the power button once.
2.2.3 Using the Plaque Remover and Dental Mirror (for ADB0008 Model
Only)
NOTE
You should rinse the brush head under warm running water before the first use
in order to remove any residue of production materials.
NOTE
Using a plaque remover cannot substitute professional oral hygiene at the dentist.
1. Place the plaque remover on the toothbrush handle so that they fit tightly. The
metal end of the remover should be pointed in the direction shown in
Figure 10-a.
2. Turn the remover clockwise (see Figure 10-b). When properly installed, the tab on
the toothbrush handle will slide into the groove on the remover and you will hear
a click (see Figure 11).
* According to information from open sources.