AENO™ Toothbrush Operation Manual
© ASBISC Enterprises PLC. All rights reserved Document version: 1.0.0, aeno.com
Page 37 of 42
5 Storage, Transportation, and Disposal
Clean the device and its accessories before storing them. Allow them to dry completely.
The device can be stored in either a horizontal or vertical position.
If the device will not be used for an extended period of time, in order to avoid
accumulation of dust and dirt on the device casing and to avoid exposure to humidity,
it is recommended to store the device and accessories in their original packaging in a
clean, well-ventilated and closed room, out of the reach of children, away from acids
and alkalis, heating devices and avoiding exposure to direct sunlight and moisture.
Protect the device from significant changes in temperature.
ATTENTION!
If you do not use the device for a long time, charge it every 2–3 months to avoid
deep discharge of the battery.
NOTE
If these requirements are not met, ASBISC does not guarantee that the device will
retain its stated parameters due to possible loss of use of its components,
accumulation of dust, moisture or the negative impact of other factors.
The device can be transported in any type of covered transport (railroad cars, closed
cars, sealed heated compartments of airplanes, etc.) in accordance with the
requirements of current regulations applicable to fragile goods. The toothbrush and its
accessories must be stored in the original packaging during transportation.
Similar requirements of the applicable regulatory documents apply to the storage
conditions of the device in the supplier's warehouse.
NOTE
The user must observe the storage conditions (temperature and relative
humidity) specified in the table of technical specifications.
To Next Page
Loading...
