AENO DB7 - Changing Brush Heads

AENO™ Toothbrush Operation Manual
© ASBISC Enterprises PLC. All rights reserved Document version: 1.0.0, aeno.com
Page 33 of 42
3.5 Changing Brush Heads
It is recommended to replace brush heads every three months or often if the bristles
have lost their shape.
ATTENTION!
Use only the original AENO™ brush heads.
To replace the brush heads, perform the following actions:
1. Remove the worn out brush head from the device handle (see paragraph 2.3.1).
2. Clean the device handle if necessary (see subsection 3.1).
3. Place a new replacement brush head on the toothbrush handle (see
paragraph 2.2.2).