AENO DB7 - Figure 8 - Installing the Replacement Brush Head (Back View); Figure 9 - Using the Brush Head

AENO™ Toothbrush Operation Manual
Document version: 1.0.0, aeno.com © ASBISC Enterprises PLC. All rights reserved
Page 24 of 42
Figure 8 – Installing the Replacement Brush Head (Back View)
3. Wet the bristles of the toothbrush head under running water.
4. Apply the desired amount of a dental care product to the bristles.
5. Point the bristles toward the surface of the teeth at an angle of about 45° (see
Figure below).
Figure 9 – Using the Brush Head