AENO™ Toothbrush Operation Manual
Document version: 1.0.0, aeno.com © ASBISC Enterprises PLC. All rights reserved
Page 30 of 42
3 Cleaning and Maintenance
To maintain optimal condition and stable operation of the device, it is recommended
that you do the following:
• Clean the device handle after each use;
• Clean the bristles after each use;
• Clean the plaque remover (for ADB0008 model only) after each use;
• Clean the dental mirror (for ADB0008 model only) as soon as it becomes dirty;
• Replace brush heads every 2–3 months or depending on the degree of wear and
tear.
ATTENTION!
Clean the device and its accessories only after the device has been turned off and
disconnected from the power supply.
ATTENTION!
Do not use chemical and aggressive detergents, abrasive pastes, products
containing acids and solvents or metal sponges for cleaning the device and its
accessories. This can damage the device, accessories, and their coating.
ATTENTION!
Do not wash the device and its accessories in a dishwasher.
3.1 Cleaning the Device Handle
After turning the device off, rinse it under warm running water, then wipe it with a dry
cloth.
ATTENTION!
Do not rinse the device under running water if the protective cover (see
Figure 2-a) is removed.
ATTENTION!
Do not immerse the device in water for long periods of time (more than
30 minutes).
You can also clean the device handle with a cotton cloth. Turn off the device and wipe
it with a cloth dampened with clean water. Afterwards, wipe it with a dry cloth.
To Next Page
Loading...
