AM Series Boiler Heat Exchanger Maintenance & Replacement
Technical Instruction Document
Installing of the Heat Exchanger - Continued
10. Push the heat exchanger to the left to allow aligning and seating at the right side with the
appropriate inlet openings in the flue chimney for the flue outlet and condensate drain outlet.
See Figure 4-9.
Figure 4-9: Seating the Flue and Condensate Connections
11. After seating the flue and condensate connections to the flue chimney, slip the right rear
mounting tabs at the rear of the heat exchanger under the upper and lower loosened right-
side 10mm bolts on the rear panel of the unit, as shown in Figure 4-10.
Figure 4-10: Slipping the Heat Exchanger Mounting Slots Under the Loose Bolts
TID-0132_99 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 23 of 36
Ph.: 800-526-0288 01/18/2015
To Next Page
Loading...
Need help?
General